CISCO CCENT SWITCH MAC ADDRESS LEARNING PC
CISCO CCENT SWITCH MAC ADDRESS LEARNING SIMULATOR

Let’s take a look at some of those commands. Now there is some initial configuration or basic configuration we can do to test connectivity and that first thing would be going and setting an IP address and maybe configuring a host name. You just simply plug the cable in or the power cord in the back and then go in and hook the machines up and it will function. All the switch needs is power plugged into the back, and a lot of switches do not even have a power switch. 1.40, get a response back, so I don’t have to do anything to the switch to get it to function, it’s not a like a router. I can go in and ping 192.168.1.20 and I’ll get a response back. If I go in to Palestra computer one and I ping some of the other machines, IP config allows me to view my IP address, that’s 192168.1.10. If I just leave the switch alone, plug power into it, hook the computers up to it, the witch will do its switching function, it will allow the machines to communicate. Now, all I need to do to allow these machines to connect to each other is nothing.

Interface VLAN1 which is where we put our IP address and I will be going over that in a moment and then we see the rest of the configuration for the switch here is totally blank.

We see a VTP domain which again we will talk about later. Name, switch, IP subnet zero allows it to use a zero subnet, spanning tree we will be talking about later and all 12 interfaces on the switch have no configuration underneath them. Show running-config allows me to view how the switch is initially configured.

CISCO CCENT SWITCH MAC ADDRESS LEARNING SIMULATOR

I connect to the switch in the CCNA simulator and I go from user mode to privilege mode by typing in the enable command and real quick I’m going to go in and take a look at the initial configuration of the switch. The four machines have been configured with their IP addresses, but nothing has been done to the center switch. It does have power to it and does have the cabling connected up. I have not done any configuration to the switch whatever. I’ve set up a center switch, switch one and then the four machines and connected them to the appropriate ports. Now I’ve gone in and configured the design in the CCNA simulator I’m using. So let’s take a look at what we have to go in and do to the switch that will allow these machines to have connectivity with one another. 1, but I have not configured the switch IP.

CISCO CCENT SWITCH MAC ADDRESS LEARNING PC

24 is bit wise notation while subnet mask is 255.255.255.0 and I’ve given each PC and IP address of. I’m using the 192.168.1.0 network address with the /24 subnet mask. Palestra 1 is connected to port one, Palestra 2, port two, Palestra 3, port three and Palestra 4 on port four. The 2950 switch is the switch that the Cisco CCNA test revolves around. I have a center switch which is 2950 switch. Now I’ve brought up a diagram of a network I’ve loaded into my CCNA simulator.

Cisco ccent switch mac address learning